English−34
Language Selects the language used by the OSD.
OSD Turn Off The OSD menu will stay open as long as it is in use. You can select how long the monitor waits after the
last touch to close the OSD menu. The preset choices are 5 - 120 seconds by 5-second increments.
Auto Adjust (Analog input only) [Left/Right], [Down/Up], [H.Size] and [Fine] are adjusted automatically when new timing is detected.
Auto Contrast (Analog input only) Adjusts the image displayed for non-standard video inputs.
FACTORY PRESET Resets all OSD control settings back to the default settings except [Language].
Input Select Selects the input signal source.
Auto, DSUB, HDMI, DisplayPort.
Audio Mute Mutes the speaker or headphone output.
Audio Volume Controls the volume of the speakers or headphones.
DDC/CI Turns the [DDC/CI] function [On] or [Off].
This function gives a warning when there is no horizontal or vertical sync. After power is turned on or when there
is a change of input signal, the window will appear. The message will close automatically.
This function gives a recommendation of the optimized resolution and refresh rate. After the power is turned
on, or there is a change of input signal, or if the video signal doesn’t have proper timing, the message will
appear. To close the message, please disconnect signal cables.
This function noties of the increase in
power consumption. The message appears when adjusting [DV MODE], [Brightness], or [ECO MODE] settings.
To change the setting, select [Yes] in the message window and press the key.
To return without changing, select [No] in the message window and press the key.
To Next Page
Loading...
Need help?
General