English−7
English
Handling the power cord.
Handle the power cord with care. Damaging the cord could lead to re or electric shock.
• When connecting the power cord to the product’s AC IN terminal, make sure the connector is
fully and rmly inserted.
• Make sure the power cord cannot be easily disconnected.
• Do not connect or disconnect the power cord with wet hands.
• When connecting or disconnecting the power cord, pull the power cord out by holding onto its
plug.
• When cleaning the product, for safety purposes, unplug the power cord from the power outlet
beforehand. Regularly dust off the power cord by using a soft dry cloth.
• Before moving the product, make sure the monitor power is off, then unplug the power cord
from the power outlet and check that all cables connecting the product to other devices are
disconnected.
• When you are not planning to use the product for an extended period of time, always unplug the
power cord from the power outlet.
• This equipment is designed to be used in the condition of the power cord connected to the
earth.
If the power cord is not connected to the earth, it may cause electric shock. Please make sure
the power cord is connected to the wall outlet directly and earthed properly. Do not use a 2-pin
plug converter adapter.
Please conrm the distribution system in building installation shall provide the circuit breaker rated
120/240 V, 20 A (maximum).
Do not bind the power cord.
It may trap heat and cause a re.
Do not climb on the table where the product is installed. Do not install the product on a wheeled
table if the wheels on the table have not been properly locked. The monitor may fall, causing
damage to the product or personal injury.
Installation, removal, and adjustment of the stand.
• Handle with care when pulling the stand as it might pinch your ngers.
• Please securely hold the monitor stand while removing the screws to prevent the monitor stand
from falling. It may case personal injury.
• Before rotating the screen, disconnect the power cord and all cables from the product.
Otherwise, the power cord or cables might pull with excessive force and cause personal injury
or damage to the product.
• When rotating the screen, slide it to the highest level and set it to the maximum tilt.
Otherwise, it could cause personal injury or knock the screen on the desk.
Please check the Specications for the available Tilt range when installing the product on a exible
arm.
Do not tilt the monitor downward beyond 5 degrees. Doing so can cause the LCD panel to separate
and potentially fall out causing damage to the product or personal injury.
To Next Page
Loading...
Need help?
General