To Next Page

To Previous Page

English-13

English

Recovering from no image

If monitors have no image after setting DP OUT MULTISTREAM, please set as follows:

1. Turn off the computer.

2. Touch the “MENU” key to show the No Signal OSD menu.

3. Touch the “ ” key to show VIDEO INPUT menu.

4. Touch “ ” or “ ” to show to set the DisplayPort switch menu.

5. Select DP VER “1.1” to switch the DisplayPort setting.

6. Touch MENU to close the OSD menu.

7. Turn on the computer.

NOTE: MST (multi-stream transport) and SST (single-stream transport) requires the corresponding display card.

Check to make sure that the display card supports MST (multi-stream transport).

Contact your supplier for detailed information.

NOTE: Monitors should be connected by the included DisplayPort cable.

Questions and Answers:

Need help?

Do you have a question about the NEC MultiSync EA245WMi and is the answer not in the manual?

NEC MultiSync EA245WMi Specifications

General