NEC MultiSync V654Q User Manual

English-15
English
1. Determine the installation location
CAUTION
• Installingyourmonitormustbedonebyaqualied
technician. Contact your supplier for more information.
• MOVINGORINSTALLINGTHEMONITORMUSTBE
DONE BY FOUR OR MORE PEOPLE. Failure to follow
this caution may result in injury if the LCD monitor falls.
• Donotmountoroperatethemonitorupsidedown.
NOTE: This monitor has internal temperature sensors and
cooling fans, including a fan for the Option Board.
If the monitor becomes too hot, the cooling fans
will turn on automatically.
The Option Board’s fan is active although the
temperature is lower than normal operating
temperature for cooling the Option Board. If the
monitor becomes overheated while the cooling
fan is running, a “Caution” warning appears. If the
“Caution” warning appears, stop using the unit,
turn off the power and allow it to cool. Using the
cooling fans will reduce the likelihood of early unit
failure and may help reduce image degradation
and “Image Persistance”.
CAUTION: If the monitor is used in an enclosed area or
if the LCD panel is covered with a protective
screen, please check the inside temperature
of the monitor by using the “HEAT STATUS”
control in the OSD (see page 41). If the
temperature is higher than the normal
operating temperature, please turn the
cooling fan to ON within the FAN CONTROL
menu within the OSD (see page 41).
IMPORTANT: To avoid scratching the LCD panel, always
place a soft cloth, such as a blanket that is
larger than the monitor’s screen area, on the
table before laying the monitor face down.
2. Install the remote control batteries
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
A. Press and slide to open the cover.
B. Align the batteries according to the (+) and (–) indications
inside the case.
C. Replace the cover.
CAUTION: Incorrect usage of batteries can result in
leaks or bursting.
NEC recommends the following battery use:
• Place“AAA”sizebatteriesmatchingthe(+)and(-)signs
on each battery to the (+) and (-) signs of the battery
compartment.
• Donotmixbatterybrands.
• Donotcombinenewandoldbatteries.Thiscanshorten
battery life or cause liquid leakage of batteries.
• Removedeadbatteriesimmediatelytopreventbattery
acid from leaking into the battery compartment.
• Donottouchexposedbatteryacid,itmayinjureyourskin.
NOTE: If you do not intend to use the Remote Control for
a long period of time, remove the batteries.
3. Connect external equipment
(See page 17, page 18 and page 19)
• Toprotecttheexternalequipment,turnoffthemainpower
before making connections.
• Refertothe user’s manual of your equipment for further
information.
NOTE: Do not connect/disconnect cables when turning
on the monitor or other external equipment, as this
may result in a loss of the monitor image.
4. Connect the supplied power cord
• Themonitorshouldbeinstalledclosetoaneasily
accessible power outlet.
• Fastenthepowercordtothemonitorbyattachingthe
screw and clamp. (Recommended Fasten Force:
139-189N•cm).
• Fullyinserttheprongsintothepoweroutletsocket.
A loose connection may cause image instability and may
pose a fire hazard.
NOTE: Please refer to the “Important Information” section
of this user’s manual for proper selection of an AC
power cord.
Screw
Clamp
Setup

NEC MultiSync V654Q Specifications

General

Brand	NEC
Model	MultiSync V654Q
Category	Monitor
Language	English