Installation
20
NETGEAR GS110T Smart Switch
Step 5: Applying AC Power
Before connecting the power cord, select an AC outlet that is not controlled by a wall switch,
which can turn off power to the switch. After selecting an appropriate outlet, use the following
procedure to apply AC power:
1. Connect the end of the supplied IEC AC power adapter cable to the power receptacle
on the back of the switch.
2. Connect the AC power adapter cable into a power source such as a wall socket or power
strip.
When applying power, the Power LED on the switch’s front panel illuminates.
If the Power LED does not go on, check that the power cable is plugged in correctly and that
the power source is good. If this does not resolve the problem, refer to Appendix A.
Step 6: Managing the Switch using a Web Browser or the
PC Utility
The GS110T Smart Switch contains software for viewing, changing, and monitoring the way it
works. This management software is not required for the switch to work. The ports can be
used without using the management software. However, the management software enables
the setup of VLAN and Trunking features and also improves the efficiency of the switch,
which results in the improvement of its overall performance as well as the performance of the
network.
After powering up the switch for the first time, the Smart Switch can be configured using a
Web browser or a program called Smart Control Center Utility. For more information about
managing the switch, see the Gigabit Advanced Smart Switch Series Software Administration
Manual on the Smart Switch Resource CD.
Note: When the device powers up, there is a default IP
address already configured on the device. The
default IP address is 192.168.0.239 and subnet
mask 255.255.255.0.
To Next Page
Loading...
Need help?
General