NETGEAR GS316P User Manual

Register with the NETGEAR Insight app
1. Search for NETGEAR Insight and download the latest app.
2. Set up a NETGEAR account if you do not have one.
3. Tap the menu in the upper-left corner.
4. Tap REGISTER ANY NETGEAR DEVICE.
5. Enter the serial number located on the bottom of the switch, or use the
camera on your mobile device to scan the serial number bar code.
6. Tap GO.
The switch is registered and added to your account. You can now view the
switch in the NETGEAR Insight app.
Note: %HFDXVHWKLVLVDQXQPDQDJHGVZLWFK\RXFDQQRWFRQŴJXUHRUPDQDJHLW
in NETGEAR Insight.
Connect the switch
Sample connections
PoE VoIP
Phone
Wave 2
Wireless AP
PoE+ security
camera
Router
GS316PP
Internet
/DSWRS
Smart
phone
Internet
PoE+

NETGEAR GS316P Specifications

General

Switch type	Unmanaged
Quality of Service (QoS) support	Yes
Power connector	DC-in jack
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
10G support	No
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
Jumbo frames	9216
Latency (1 Gbps)	3.7 µs
MAC address table	4000 entries
Packet buffer memory	1 MB
Packet forwarding rate (1 Gbps)	1448000 pps
Heat dissipation	437.42 BTU/h
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 90 %
Input current	2.4 A
DC input voltage	54 V
Power consumption (max)	127.9 W
Mean time between failures (MTBF)	2362192 h
Product color	Black
Housing material	Metal
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	102 mm
Width	286 mm
Height	27 mm
Weight	880 g