NETGEAR Nighthawk AX4 User Manual

Rear panel
The following figure shows the rear panel connectors and buttons.
1 2 3 4 5 6 7
Figure 3. Rear panel
The rear panel contains the following components:
1. Power On/Off button. Press the Power On/Off button to provide power to the
router.
2. DC power connector. Connect the power adapter that came in the product package
to the DC power connector.
3. Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DSL modem.
4. Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
the router to LAN devices.
5. USB 3.0 port. One USB 3.0 port to connect USB storages devices to your router.
6. Reset button. Pressing the Reset button resets the router. If the Reset button is
pressed for at least 10 seconds and the Power LED blinks white, the router returns
to its factory settings.
7. LED On/Off switch. Move the LED On/Off switch to the Off position to turn off the
router LEDs. The Power LED stays lit even if the LED On/Off switch is in the Off
position.
User Manual11Hardware Setup
Nighthawk AX4 4-Stream AX3000 WiFi Router

NETGEAR Nighthawk AX4 Specifications

General

Brand	NETGEAR
Model	Nighthawk AX4
Category	Network Router
Language	English