LED behavior
When you sync a satellite to the router, the LED behavior for a satellite that comes in a
WiFi system is different from the LED behavior for add-on satellites.
Orbi WiFi system LEDs
The following table describes the LED behavior for an Orbi router and Orbi satellites
that are purchased together and come in the same package.
Table 1. Orbi WiFi System router and satellite LED descriptions
LED BehaviorLED
The Power LED is located above the Power On/Off button on the rear panel. Note: The wall
plug satellite does not include a Power LED.
•
Solid green. Power is on.
•
Solid amber. The router or satellite is booting.
•
Blinking amber. The router or satellite is resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
Power LED
The ring LED is located on the top.
•
Pulsing white. The router is booting or someone pressed the Sync button.
•
Off. The router finished booting and is working normally.
•
Solid white. The router is resetting to factory default settings.
•
Solid magenta. The router cannot connect to the Internet. See You cannot access the Internet
on page 135.
Router ring LED
This satellite is included when you buy an Orbi router. The ring LED is located on the top.
•
Pulsing white. The satellite is booting.
•
Blue for three minutes. The connection between the satellite and the router is good.
•
Amber for three minutes. The connection between the satellite and the router is fair.
•
Magenta. The satellite failed to sync to the router. See The router and satellite do not sync
on page 133.
•
Off. The satellite synced to the router and is working normally.
Satellite ring
LED
Optional Orbi add-on satellite LEDs
You can purchase add-on Orbi satellites (sold separately) and add them to your Orbi
network.
User Manual9Overview
Orbi WiFi System
To Next Page
Loading...
Need help?
General
