To Next Page

To Previous Page

Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3

Advanced Configuration 6-13

202-10090-01, April 2005

If another device on your network will be the DHCP server, or if you will manually configure the

network settings of all of your computers, clear the ‘Use router as DHCP server’ check box.

Otherwise, leave it checked.

Specify the pool of IP addresses to be assigned by setting the Starting IP Address and Ending IP

Address. These addresses should be part of the same IP address subnet as the router’s LAN IP

address. Using the default addressing scheme, you should define a range between 192.168.1.2 and

192.168.1.253, although you may wish to save part of the range for devices with fixed addresses.

The router will deliver the following parameters to any LAN device that requests DHCP:

• An IP Address from the range you have defined

• Subnet Mask

• Gateway IP Address (the router’s LAN IP address)

• Primary DNS Server (if you entered a Primary DNS address in the Basic Settings menu;

otherwise, the router’s LAN IP address)

• Secondary DNS Server (if you entered a Secondary DNS address in the Basic Settings menu

Using Address Reservation

When you specify a reserved IP address for a PC on the LAN, that PC will always receive the

same IP address each time it access the router’s DHCP server. Reserved IP addresses should be

assigned to servers that require permanent IP settings.

NETGEAR WGT624 User Manual

Other manuals for NETGEAR WGT624