20 1-866-NEUTON1 (638-8661) www.neutonowners.com
Controls and Features
Make certain that you are familiar with the Controls, Parts, and operation of your NEUTON Mower
before using it.
⇒ Safety Key Slot
The Safety Key Slot is for the Safety Key.
⇒ Safety Key
The Safety Key, after you insert it into the Mower, allows the Motor to start and run. You can insert
the Safety Key either way – it has no front or back. You should remove the Safety Key when not in
use.
The Safety Key has a Built-In Circuit Breaker to protect the Motor.
NOTE: If the Built-In Circuit Breaker trips, the white Button on top of the Safety Key will pop up. Before
attempting to restart the Mower, push the white Button all the way down until it locks into place.
⇒ Start Knob
The orange Start Knob is a safety feature that you must push across to the left before the Control Bar
can be depressed.
⇒ Control Bar
The orange Control Bar is a safety feature. You must squeeze the Bar into the Handlebar for the
Motor to start and run, and the Cutting Blade to spin. When the Control Bar is released, the Motor
shuts off and the Blade stops spinning within three (3) seconds.
⇒ Mower/Auxiliary Switch
The Mower/Auxiliary Switch controls the optional Mower attachments. This Switch has two (2)
settings.
• Mower (rear position), used for normal mowing, and
• Auxiliary (forward position), used when operating an attachment. For more information about
options available for your NEUTON Mower, see “Chapter 6: Optional Attachments”.
To Next Page
Loading...
Need help?
General
