Neuton CE5.2 User Manual

NEUTON CE5.2 Battery-Powered Mower - Safety & Operating Instructions 29
Charging with the Battery out of the Mower
1. Remove the Battery from the Mower.
2. Plug the round Charger Connector into the Charger
Receptacle on the Battery (Figure 30).
3. Plug the 110V Charger plug into a wall outlet. The RED
light on the Battery will illuminate indicating a
connection between the Battery and the Charger and
that the Battery is charging.
4. After twenty (20) to thirty (30) hours, the Battery should
be completely recharged. The LED on the Battery will not
turn OFF or change colors.
NOTE: The amount of time needed to completely recharge the Battery depends on the level of
discharge during use. If you used the Battery for the full forty-five (45) to sixty (60) minutes, or
have drained the Battery to the point where the machine will no longer operate, it will take
almost the full thirty (30) hours to recharge the Battery completely.
5. Remove the Charger from the Battery and from your standard 110-Volt wall outlet and place
both the Battery and the Charger in a DRY environment for storage until you need them
again.
NOTE: For the first five (5) hours, the Charger may be warm to the touch. This is normal and does not
indicate a problem.
ALWAYS KEEP THE BATTERY IN A DRY PLACE.
Disconnecting the Charger
Remember to disconnect the Battery from the Charger using this sequence:
1. Pull the plug from the Charger out of the wall outlet.
2. Disconnect the Charger from the Battery.
ALWAYS DISCONNECT THE CHARGER FROM THE ELECTRICAL (WALL) OUTLET FIRST, AND THEN
DISCONNECT THE ROUND CHARGER PLUG FROM THE BATTERY. IF YOU REMOVE THE ROUND CHARGER
PLUG FIRST, THE EXPOSED CONNECTOR COULD BE ACCIDENTALLY SHORT-CIRCUITED BY FOREIGN
MATERIAL, WHICH MIGHT CAUSE A FIRE.
Figure 30

Neuton CE5.2 Specifications

General

Brand	Neuton
Model	CE5.2
Category	Lawn Mower
Language	English