EasyManuals Logo
Home>Neuton>Lawn Mower>CE6.3

Neuton CE6.3 User Manual

Neuton CE6.3
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
14 www.neutonowners.com
Chapter 3: Operating Your NEUTON Mower
NOTE: If the Mower Battery is not fully charged or if you are unpacking a new Mower for the first time, read “Chapter 4: Charging
and Caring for the Battery” before operating the Mower. You should charge the Battery for ten (10) to (12) twelve hours
maximum before use.
Starting the Motor and Engaging the Blade
Starting, stopping, and restarting an electric Motor repeatedly within a few seconds can generate a great deal of heat and
damage the Motor. To protect the life of your NEUTON Mower, always wait at least five (5) seconds after stopping before
restarting the Mower.
The cutting Blade always turns when the Motor is running; there is no clutch to allow the Blade to stop rotating while the
Motor is running.
1. Perform the Daily Checks listed on the back cover of this manual.
2. Insert the Safety Key into the Key Slot (Figure 26). You can insert the Safety
Key either way and it should snap into place. The green Status Indicator Light
on the Lower Crossbar should come on when you place the Power/Mode
Switch in either the Mow or Auxiliary position.
Starting the Mower
1. Slide the orange Start Knob to your left (Figure 27).
2. Squeeze and hold the orange Control Bar (Figure 28). The orange Start Knob fits
snugly into the Slot on top of the Handlebar.
3. Continue to hold the Control Bar against the Handlebar for as long as you want the
Motor to run.
If the Mower does not start, first check for simple solutions:
Make sure the Battery is in, the Safety Key is in, and the Status Indicator Light is green.
Make sure the Power/Mode Switch is in the Mower position.
Make sure the white Circuit Breaker Button on the Safety Key is depressed.
Did you follow the two (2)-step Start sequence: slide the orange Start
Knob to the left, then squeeze and hold the Control Bar?
NOTE: If the Mower still does not start, follow the steps in “Chapter 6:
Troubleshooting Tips”.
The orange Control Bar is a safety device; do not tamper with it.
Stopping the Motor and Blade
Simply releasing the orange Control Bar stops the Motor and Blade.
The Blade continues to rotate for a few seconds after you shut off the Motor.
After mowing is complete, make sure to move the Power/Mode Switch to the center, OFF position. The Status Indicator Light
should turn off. If the Mower is stored with the Power/Mode Switch in either the Mow or Trim position with the Battery in the
Mower, the Status Indicator Light will remain ON and will drain your Battery between uses.
Figure 26
Figure 2
Figure 28
Safety
Key

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Neuton CE6.3 and is the answer not in the manual?

Neuton CE6.3 Specifications

General IconGeneral
BrandNeuton
ModelCE6.3
CategoryLawn Mower
LanguageEnglish

Related product manuals