SAFETY REGULATIONS
x
J Do not alter the calibration of the pressure relief
valves in the various hydraulic circuits (hydrostatic
steering, hydraulic lift, auxiliary distributors, etc.).
J Avoid using the tractor in unsuitable physical
conditions, stop work instead.
J Enter and leave the tractor using the steps and
handles provided. Keep these fittings free of mud
and debris.
J Always operate with the cab or roll bar correctly
and securely fitted on the tractor: periodically check
that the fittings are not loose and that all parts of the
structure are free from any damage and deformation.
Do not modify the roll bar by welding parts, drilling
holes, etc., as this could adversely affect the rigidity
of the struc tu re .
STARTING THE TRACTOR
J Before starting the engine, check that the hand-
brake is on and that the gears and power take--off are
disengaged, even if the tractor is fitted with a start--up
safety device. Never disconnect the start--up safety
switch.If the switch does not work correctly, contact
your local dealer for eventual repair operations.
J Before starting the engine, make sure that all at-
tached implements are lowered to the ground.
J Before starting the engine, check that all covers
and guards are correctly in position (roll bar, bonnet
side panels, power take--off guard, front axle trans-
mission shaft cover, etc.).
J Never start or manoeuvre the tractor unless
seated in the driving position.
24135
J Before moving the tractor, always check that the
area is free of persons or obstacles.
24134
J Never run the engine in a closed space without
ensuring adequate ventilation. Exhaust fumes are
damaging to the health and can be lethal.
To Next Page
Loading...
Need help?
General
