Nexo GEOM1210-I User Manual

PRESET GEOM12
GEOM1210-I - GEOM1220-I Page 5 / 20
PRESET GEOM12
Please consult nexo-sa.com for NEXO TD Controllers firmware information.
 For the GEOM1210 or GEOM1220, with or without directivity flanges, the following setups are available:
Passive Mode
o Setup for one stand-alone box, with high-pass at 50, 60, 75, 85, 95 or 120 Hz.
o Setup for arrays from 2 to 3 boxes, with high-pass at 50, 60, 75, 85, 95 or 120 Hz.
o Setup for arrays from 4 to 6 boxes, with high-pass at 50, 60, 75, 85, 95 or 120 Hz.
o Setup for arrays from 7 to 12 boxes, with high-pass at 50, 60, 75, 85, 95 or 120Hz.
o Setup for Stack Monitor, with high-pass at 50, 60 or 75 Hz.
Active Mode
o Setup HF for arrays from 2 to 3 boxes, 1 kHz– 20 kHz
o Setup HF for arrays from 4 to 6 boxes, 1 kHz– 20 kHz
o Setup HF for arrays from 7 to 12 boxes, 1 kHz– 20 kHz
o Setup LF for arrays from 2 to 3 boxes, 50, 60, 75, 85, 95 or 120 Hz to 1kHz.
o Setup LF for arrays from 4 to 6 boxes, 50, 60, 75, 85, 95 or 120 Hz to 1kHz.
o Setup LF for arrays from 7 to 12 boxes, 50, 60, 75, 85, 95 or 120 Hz to 1kHz.
• 1 Box
ox
Default Cross over on one box 50 Hz Front Fill, multi-diff, sound reinforcement all short throw application;
High SPL Small system using 2x GEOM12 and 2x MSUB18 in 85 Hz;

Nexo GEOM1210-I Specifications

General

Brand	Nexo
Model	GEOM1210-I
Category	Stereo System
Language	English