op. mode
RS PRGH
DXWR
PDQXDO
DGG KHDW RQO\
op. mode
Setting range: auto, manual, add. heat only
Default value: auto
functions
Setting range: compressor, addition, heating
Menu
4.2
The heat pump operating mode is usually set to "auto". It is also possible to
set the heat pump to "add. heat only", but only when an addition is used,
or "manual" and select yourself what functions are to be permitted.
Change the operating mode by marking the desired mode and pressing the
OK button. When an operating mode is selected it shows what in the heat
pump is permitted (crossed out = not permitted) and selectable alternatives
to the right. To select selectable functions that are permitted or not you mark
the function using the control knob and press the OK button.
Operating mode auto
In this operating mode you cannot select which functions are to be permitted
because it is handled automatically by the heat pump.
Operating mode manual
In this operating mode you can select what functions are permitted. You
cannot deselect "compressor" in manual mode.
63NIBE™ F470Chapter 3 | F470 – at your service
To Next Page
Loading...
Need help?
General
