Nibe F750 User Manual

temperature
WHPSHUDWXUH 
Menu
1.1
If the house has several climate systems, this is indicated on the display by a
thermometer for each system.
Set the temperature (with room sensors installed and activated):
Setting range: 5 - 30 °C
Default value: 20
The value in the display appears as a temperature in °C if the heating system
is controlled by a room sensor.
To change the room temperature, use the control knob to set the desired
temperature in the display. Confirm the new setting by pressing the OK but-
ton. The new temperature is shown on the right-hand side of the symbol in
the display.
Setting the temperature (without room sensors activated):
Setting range: -10 to +10
Default value: -1
The display shows the set values for heating (curve offset). To increase or re-
duce the indoor temperature, increase or reduce the value on the display.
Use the control knob to set a new value. Confirm the new setting by pressing
the OK button.
31NIBE™ F750Chapter 3 | F750 – at your service

Nibe F750 Specifications

General

Type	Exhaust Air Heat Pump
Refrigerant	R410A
Integrated Water Heater	Yes
Control System	NIBE SMO 40
Smart Grid Ready	Yes
Max Flow Temperature	65°C
Compressor Type	Scroll
Power Supply	3x400V 50Hz