To Next Page

To Previous Page

7.1.1) Level one programming: functions

At level one, the functions can be activated or deactivated.

At level one, LED P1 is always on; if LEDs L1, L2…L5 are on, the

functions are activated; if the LEDs are off, the functions are deacti-

vated. A flashing LED indicates which function has been selected;

short flashes indicate the function has been deactivated; long flash-

es indicate the function has been activated. Press P3 to pass from

part one programming to part two programming, and vice-versa.

Table “A1” Entering level one programming: Example

1. Press and hold down buttons P1 and P2 for at least 3 seconds

The programming mode has been entered if all the Leds start flashing quickly

1. Press P1 repeatedly until the flashing Led reaches the function required.

2. Press P2 to activate or deactivate the function.

Table “A3” To pass from part one to part two of level one (and vice-versa): Example

1. Press P3. button

Table “A4” To exit level one and save the modifications: Example

1. Press and hold down buttons P1 and P2 for at least 3 seconds

P1 P2

Table “A2” Activating or deactivating a function: Example

P1 P2

3s or 60s,

Table “A5” Exiting level one and delete the modifications: Example

1. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply

7.1.2) Level two programming: parameters

The function parameter can be chosen at level two. Level two can

only be reached from level one.

At level 2 the P1 Led flashes quickly while the 5 Leds (L1, L2…L5)

indicate the selected parameter.

Table “B1” Entering level two programming: Example

1. Enter level one programming by pressing P1 and P2 for at least 3 seconds

1. Press P2 repeatedly until the Led reaches the desired parameter

Table “B3” Returning to level one: Example

1. Press P1

Table “B4” Exiting level one and saving modifications: Example

1. Press and hold down buttons P1 and P2 for at least 3 seconds

P1 P2

Table “B2” Selecting the parameter: Example

P1 P2

2. Select the function by pressing P1 until the flashing Led reaches the point required.

3s or 60s,

Table “B5” Exiting level one and cancelling modifications: Example

1. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply

3. Enter level two by pressing the P2 button for at least 3 seconds

Brand	Nice
Model	Pop
Category	Gate Opener
Language	English

Nice Pop User Manual

Table of Contents

Other manuals for Nice Pop

Questions and Answers:

Nice Pop Specifications

Related product manuals