16
Basic Steps for Shooting and Playback
Preparation 2 Charge the Battery
1 Prepare the included Charging AC Adapter EH-69P.
• If a plug adapter* is included, attach the plug adapter to the plug
on the Charging AC Adapter. Push the plug adapter firmly until it
is securely held in place. Once the two are connected, attempting
to forcibly remove the plug adapter could damage the product.
* The shape of the plug adapter varies according to the country
or region in which the camera was purchased.
The Charging AC Adapter comes with the plug adapter
attached in Argentina and Korea.
2 Make sure the battery is installed in the camera, and then connect the
camera to the Charging AC Adapter in order of
1
to
3
.
• Keep the camera turned off.
• Be sure that plugs are properly oriented. Do not attempt to insert plugs at an angle,
and do not use force when connecting or disconnecting the plugs.
• The charge lamp slowly flashes green to indicate that the battery is charging.
• About 2 hours and 30 minutes are required to charge a fully exhausted battery.
• When the battery has been completely charged, the charge lamp turns off.
• See “Understanding the Charge Lamp” (A17) for more information.
3 Disconnect the Charging AC Adapter from the electrical outlet and
then disconnect the USB cable.
• When the camera is connected to the electrical outlet with the EH-69P, the camera
cannot be turned on.
USB Cable UC-E6 (included)
Electrical
outlet
Charge lamp
To Next Page
Loading...
Need help?
General
