Film Rewind
This section explains mid-roll rewind and what to do if the film does not
rewind .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
..
. . . . . . . . . . . . .
78
Mid-
roll
rewind
•
To
rewind film at mid-roll, press the two film rewind
El~
buttons simultaneously for approx. 1 sec.
Shutter sound
is
let out and film rewind will start.
· 0
___
, 0
__
, 0 _ and then 0 appear
in
the LCD panel
during film rewind and the frame counter counts
backwards until rewind is complete.
• Film is completely rewound when a blinking E
shows
in
the LCD panel and 8
in
the viewfinder.
(E
appears without blinking and 8 disappears when
the exposure meter
is
off.) Make sure E and 8
are
blinki
ng
, open the camera back away from sunlight
and remove the film cartridge.
If film does not start to rewind or film
rewind stops at mid-roll
• When battery power is very low, or at low
temperatures, film may not start rewinding or film
rewind may stop at mid-roll, and
0
__
, frame
number and insufficient battery power indication
C-.J will blink
in
the
LC
D panel, and 8 _ and CA!I
will blink
in
the viewfinder.
In
this case, turn the
power switch off, change batteries, then turn the
power switch
on
to
rewind film again.
(The
frame
counter display does not change until camera back
is opened once and closed again after removing the
film cartridge.)
~
i! : Warning indications
in
the viewfinder can
be set not to appear (p. 7
4)
.
To Next Page
Loading...
Need help?
General
