4
6. Cautions on heat from the light source
The lamp and the lamphouse become extremely hot when the lamp
is turned on. Follow the cautions below to prevent burns and fire.
• To avoid burns, do not touch the lamp and the lamphouse while
the lamp is on or for approximately thirty minutes after it has
been turned off.
• To avoid the risk of fire, do not place fabric, paper, or highly
flammable volatile materials (i.e. gasoline, petroleum benzine,
paint thinner, and alcohol) near the lamphouse while the lamp is
on or for about thirty minutes after it has been turned off.
7. Cautions on lamp replacement
• When replacing the lamp, wait approximately thirty minutes
after turning off the lamp, and make sure that the lamp and the
lamphouse have cooled sufficiently.
• To prevent electric shock and product damage, turn off the power
switch on the power supply before replacing the lamp.
1. Check the light source
When using an illuminator, be sure to use the specified rating only.
Use of other rating may result in damage to the equipment. Refer to
the instructions for the lamp rating.
2. Cautions on assembling the product
• Take care to avoid pinching your fingers and hands.
• Scratches and dirt (i.e. fingerprints) on the lenses will degrade
the image quality. When assembling the product, be careful not
to scratch or directly touch the lenses.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
