AssemblyandUsefortheBowl
ASSEMBLY
WARNING: Never leave the appliance unattended while in use.
Fig. 1
Fig. 2
ASSEMBLY
Fig. 3a
Fig. 3b
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Align and lower the Bowl onto the motor base.
(Fig. 1) Handle should be aligned slightly to the
right of the “LOCK” symbol on the motor base.
3 Rotate the bowl clockwise as far as it will go to
lock in place. (Fig.2)
4 The bowl can be placed on the motor base two
ways; the handle can be on the front right corner or
the front left corner. (Fig.3a,Fig.3b)
5 Holding the desired blade by the top of the shaft,
place it onto the drive gear inside the bowl. Ensure
that the attachment is seated properly and is
standing upright. (Fig.4)
NOTE: The blade will fit loosely on the drive gear.
6 Add the ingredients to the bowl, making sure that
they do not exceed the highest measured marking
line on the side of the bowl.
7 Plug the power cord into the electrical outlet and
press the power button ( ).
NOTE:Asasafetyfeature,thepowerbutton
( )willashandthemotorwillnotworkif
thebowlandlidarenotinstalledcorrectly.
Whenthebowlandlidareinstalledproperly,
thepowerbutton( )willbesolid,indicating
thattheapplianceisreadyforuse.
8 Holding the lid by the handle in the upright
position, place it on top of the bowl aligning the
arrow ( ) located on the lid with the arrow
( ) located on the bowl’s handle. (Fig. 5) Press the
handle down until you hear a click.
NOTE:The64oz.bowlisnotintendedfor
blendingdrinks.Donotoverll.
NOTE: To add liquids during
processing, open the drizzle
hole on the top of the lid and
pour the liquid slowly into the
mixture.
Fig. 4
Fig. 5
BL771_30_BL771C_30_IB_ENG_121206_6.indd 11 12-12-06 11:23 AM