ASSEMBLY
AssemblyandUsefortheMiniPrepBowl
USE
WARNING: Never leave the appliance unattended while in use.
USING THE 3 CUP MINI PREP BOWL
1 Place the 64 oz. bowl onto the motor base. (See
assembly instructions on page 11.)
2 Holding the spindle by the shaft, place it onto the
gear shaft inside the 64 oz. bowl. Ensure that the
attachment fits around the gear shaft and that it is
standing straight. (Fig. 1)
3 Place the mini prep bowl aligning the spindle inside
the center post. (Fig.2)
4 Hold the prep bowl blade by the shaft and carefully
place it over the center post of the mini prep bowl.
(Fig. 3)
5 Add ingredients into the mini prep bowl.
6 Holding the lid by the handle in the upright
position, place it on top of the 64 oz. bowl aligning
the arrow ( ) located on the lid with the arrow
( ) located on the bowl’s handle. (Fig.4) Press the
handle down until you hear a click.
7 Plug the power cord into the electrical outlet and
press on the power button ( ).
8 Select the speed that best suits your needs.
For best results, press the Pulse button in short
intervals. (Fig. 5)
NOTE: Please refer to “Speed Settings & Uses”
chart for suggested uses and speeds.
9 When you have reached your desired consistencey,
stop the appliance by pressing the power button
( ) and wait for the blade to stop turning.
10 To remove the lid, pull the lid handle up to a 90°
angle and lift the lid off. (Fig.6)
11 Carefully hold the mini prep bowl blade by the
shaft and lift it out of the mini prep bowl. (Fig.7)
12 Turn the bowl counter clockwise and then lift off
the base.
NOTE:Donotllingredientspastthe“MAX”
llline.
Fig. 1
Fig. 4
Fig. 2
Fig. 3
Fig. 5
REMOVAL
Fig. 6
Fig. 7
BL771_30_BL771C_30_IB_ENG_121206_6.indd 13 12-12-06 11:23 AM
To Next Page
Loading...
Need help?
General
