9
bowl aligning the arrow ( ) located on
the lid with the arrow ( ) located on the
bowl’s handle. (Fig. 3)
7 Push down on the “PULSE” on the handle
to start the appliance. (Fig. 4)
NOTE: Pulse ingredients for even
chopping by pressing down in short
intervals.
IMPORTANT: When using the dough
blade or cookie paddle hold the
appliance to secure the appliance to the
counter or table top.
8 When you have reached your desired
consistency, stop pressing the lid handle
and wait for the attachment to stop
turning.
9 To remove the lid, pull the lid handle up
to a 90° angle. Turn the bowl clockwise
to lift off the base. (Fig. 5, Fig. 6)
CAUTION: Never insert your hands in the
pitcher as the blades are sharp. Always
use a spatula to dislodge food that has
stuck to the sides of the pitcher.
10 Make sure that the unit is unplugged
when not in use.
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry,
level surface such as a counter or table
top.
2 Align and lower the bowl onto the motor
base. (Fig. 1) Handle should be aligned
slightly to the left of the “LOCK” symbol
on the motor base.
3 Rotate the container to the left as far as
it will go to lock in place. (Fig. 1)
4 Holding the desired attachment by the
shaft, place it onto the drive gear inside
the container. Ensure that the attachment
is seated properly and is standing
upright. (Fig. 2)
NOTE: The blade will fit loosely on the
drive gear.
5 Add the ingredients to the bowl, making
sure that they do not exceed the highest
measured marking line on the side of the
bowl.
6 Holding the lid by the handle in the
upright position, place it on top of the
Assembly and Use for the 40-oz. Bowl
Fig. 4
Fig. 5
Fig. 6
Fig. 2
Fig. 1
Shaft
Fig. 3
Or
ASSEMBLY PULSE REMOVAL
It’s best to add the liquid ingredients first and then the dry ingredients.
BL206Q_30_IB_ENG_111228_1.indd 9 11-12-29 10:49 AM
To Next Page
Loading...
Need help?
General
