8
IMPORTANT: Make sure that the motor
base is plugged in for use.
1 Place the motor base on a clean, dry,
level surface such as a counter or table
top.
2 Add ingredients to the single serve cup.
3 Place the single serve blade onto the cup
and screw it tightly until you have a good
seal. (Fig. 1)
4 Turn the single serve cup upside down
and place it onto the motor base, aligning
the tabs on the cup with the motor base.
Turn to the left, the unit is ready for use.
(Fig. 2)
5 Press down on the top of the cup in short
intervals to activate. (Fig. 3)
Fig. 1
Fig. 2
Assembly and Use for the Single Serve Cup
Fig. 3
Fig. 4 Fig. 5
ASSEMBLY PULSE REMOVAL
For best results, use short “PULSES”... Practice makes perfect!!
6 When you have reached your desired
consistency, stop the appliance by
removing your hand from the single
serve cup. Then turn the single serve cup
to the right (Fig. 4) and pull straight up
to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling,
do not add ingredients past the “Max” fill
line.
7 Turn the cup upright and remove the
single serve blade by twisting the blade
assembly to the left.
8 Place the To-Go drinking lid onto the
single serve drink cup, twist to seal and
enjoy!
9 Make sure that the motor base is
unplugged when not in use.
BL206Q_30_IB_ENG_111228_1.indd 8 11-12-29 10:49 AM
To Next Page
Loading...
Need help?
General
