The electrical connection should be
done by a professional according to
national, state or provincial and city
Codes.
WARNING
!
Water connections to the heat
pump should be disconnected
during winter in order to allow the
heat pump to fully drain itself.
The winterization of the heat
pump must be done before the
air temperature falls below 0°C.
WINTERIZING
1. Turn off the circuit breaker.
2. Drain the heat pump then loosen up all of
the water connectors.
3. Rinse the inside of the heat exchanger’s
cylinder with a stream of tap water for about
15 minutes to remove any chlorine residue
that could damage the heat exchanger.
4. Tilt back the unit slightly to drain all the
water from the unit.
The electrical connection should be
done by a professional according to
national, state or provincial and city
Codes.
WARNING
!
Your unit should never be tilted
more than 30°-35°, even during
transportation.
Block water inlet and outlet with a cloth or
some plastic to prevent mice or other
animals from entering the unit.
For better protection, cover your heat pump
with the Nirvana winter cover; call your
dealer for details.
Winterizing
9
To Next Page
Loading...
Need help?
General
