Get started
13
2. Connect the lead from the charger to the
socket on the bottom of your phone.
The charging time depends on the charger and
the battery used.
If the battery is completely discharged, it
may take a few minutes before the charging
indicator appears on the display or before
any calls can be made.
■ Switch the phone on and off
Warning: Do not switch the phone on when wireless phone use is
prohibited or when it may cause interference or danger.
Press and hold the end key.
If the phone asks for a PIN or a UPIN code, enter the code (displayed as ****), and
select OK.
Plug and play service
When you switch on your phone for the first time, and the phone is in the standby
mode, you are asked to get the configuration settings from your service provider
(network service). Confirm or decline the query. See Connect to service provider
support in "Configuration," p. 38 and "Configuration settings," p. 10.
■ Normal operating position
Use the phone only in its normal operating position.
Your device has an external antenna.
Note: As with any other radio transmitting
device, do not touch the antenna
unnecessarily when the device is switched
on. Contact with the antenna affects call
quality and may cause the device to operate
at a higher power level than otherwise
needed. Avoiding contact with the antenna
area when operating the device optimizes
the antenna performance and the battery life.
6061.CNEN_CNFRv2_BIL_9243972.book Page 13 Thursday, February 1, 2007 2:39 PM
To Next Page
Loading...
Need help?
General
