2. Place the card in
the slot with the
contact area
facing down (2).
3. Push the card
gently to lock it
into place. Close
the slot cover (3).
Remove a memory card
Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on
the card may be corrupted.
1. Press the power key briefly, and select Remove memory
card > Yes.
2. Open the memory card slot cover.
3. Press the memory card gently to release it.
4. Pull the card out, and press OK.
5. Close the slot cover.
Charge the battery
Your battery has been partially charged at the factory. If the
device indicates a low charge, do the following:
1. Connect the charger to a wall outlet.
2. Connect the charger to
the device.
3. When the device
indicates a full charge,
disconnect the charger
from the device, then
from the wall outlet.
You also may charge the
battery with a USB cable
with power from a
computer.
1. Connect the USB cable to the USB port of a computer and
to your device.
2. When the battery is fully charged, disconnect the USB
cable.
You do not need to charge the battery for a specific length of
time, and you can use the device while it is charging. If the
battery is completely discharged, it may take several minutes
before the charging indicator appears on the display or
before any calls can be made.
Get started
© 2009 Nokia. All rights reserved. 11
To Next Page
Loading...
Need help?
General
