Functional overview Nokia FastMile 4G Receiver Product Overview
40 3TG-00386-ABAA-TCZZA Issue: 01 DRAFT
DRAFT
• LTE 3GPP Release 12 Compliant, UE Category 12
• supports the E-UTRA bands listed in Table 3
Table 3 E-UTRA bands supported by the Nokia FastMile 4G Receiver
Band 42/43/48 (mono-band support)
Band 42/43/48 (ABA support)
Band 3 (mono-band support)
Band 7/38/40/41 (mono-band support)
Band B3/B7/B20/B32 (multi-band support)
Band B1/B3/B7/B38/B40/B41/B20/B28 (multi-band support)
6.3 Data forwarding
The Nokia FastMile 4G Receiver supports the following data forwarding methods:
Table 4 Data forwarding methods supported by the Nokia FastMile 4G
Receiver
Single APN with multi-bearers
for route mode
Recommended for using only one APN specific for Nokia FastMile 4G
Receiver
Single APN with multi-bearers
for bridge mode
Could be used for WAN of IDU with VLAN tag
Multiple APNs with bridge
mode
Used as multi-APN, separated service with APNs: each APN is for each
service.
Note in this case, a specific port should be reserved for service traffic.
Multiple APNs with mixed
mode
Can be used for separated APNs on OAM and also other APNs for
separated services:
• Only default APN is in route mode which could be OAM
• Besides APN, each APN is for each service
Can be used for using tunnel for L2 forwarding such as PPPoE
6.4 Ethernet characteristics
The following are some of the key Ethernet characteristics of the Nokia FastMile 4G
Receiver:
• provides a 1 Gbps Ethernet LAN Interface that, depending on the model of the
Nokia FastMile 4G Receiver, has the following:
• the Compact mono-band and ABA models have a pre-attached 3 m (9.8 ft) Cat5e
shielded twisted pair Ethernet cable with a male RJ 45 connector at the free end •
the Compact multi-band and models have a female RJ 45 connector that supports
To Next Page
Loading...
Need help?
General
