Basic use
15
To switch the call back to the speakerphone, switch on the
speakerphone (if it is off), or press and hold the answer/end key for
about 2 seconds.
■ Clear settings or reset
To clear the pairing settings from the speakerphone, press and hold the
power key and the answer/end key (for over 4 seconds) until the red and
green indicator lights start to alternate. After the settings are cleared,
the speakerphone enters pairing mode.
To reset the speakerphone if it stops functioning even though it is
charged, connect the speakerphone to a charger while you press and
hold the answer/end key.
■ Troubleshooting
If you cannot connect the speakerphone to your compatible device, do
the following:
• Ensure that the speakerphone is charged, switched on, and paired
with your device.
• Ensure that the Bluetooth feature is activated on your device.
• Ensure that the speakerphone is within 10 metres (33 feet) of your
device and that there are no other electronic devices between the
speakerphone and the device.
To Next Page
Loading...
Need help?
General
