EasyManuals Logo

Nova 5000 Series User Manual

Nova 5000 Series
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background image
PROPER USE
OPENING YOUR CHAIR
Tilt wheelchair to one side and push down on the seat rail until fully opened.
CLOSING YOUR CHAIR
Fold footrests to the closed/vertical position. Tilt product to one side and lift up on
seat rail until fully closed
ENTERING AND EXITING PRODUCT
Ensure that there is as little space as possible between the occupant and product when
attempting to enter or exit the product. ALWAYS ensure that the brakes are engaged
when entering and exiting product. When attempting to enter or exit the product,
ensure that the footrests are in the upward, unusable position.
MOVING THE PRODUCT
ALWAYS use the wheel hand rims for self-propulsion. If your product does not have
hand rims, then have someone assist you by pushing the product using the push
handles design for that use.
REMOVING ARMREST
Remove arms by depressing push button and lifting arms out of front and rear sockets.
FOOTREST ASSEMBLY
INSTALLING FOOTREST
1 - Hold the footrest assembly in position as if it were in ready for use.
2 - Turn the front footrest assembly to the side (so that open foot plate, which was
perpendicular to the wheel, is now parallel with the wheel).
3 - Slightly raise the assembly and place the hinge plates on the front footrest assembly
onto the hinge pins on the product frame.
4 - Rotate the footrest assembly inward, toward the inside of the wheelchair until it
locks into place (so that the foot plate is perpendicular with the wheel).
5 - Repeat for other footrest assembly.
REMOVING FOOTREST
1 - Pull the release lever inward.
2 - Rotate the front footrest assembly to the side (so that open foot plate, which was
perpendicular to the wheel, is now parallel with the wheel).
3 - Slightly lift the footrest assembly so that it comes off the hinge pins.
ADJUSTING FOOTREST HEIGHT
1 – LOOSEN the tension screw behind the footrest
2 - PRESS the footrest release push buttons and adjust to your desired setting
3 - Ensure that the footrest release buttons re-engage (push-buttons click in place).
4 – TIGHTEN the tension screw
5 of 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nova 5000 Series and is the answer not in the manual?

Nova 5000 Series Specifications

General IconGeneral
BrandNova
Model5000 Series
CategoryWheelchair
LanguageEnglish

Related product manuals