Nova COMET 14DR User Manual

7
127-0919-001
Assembling the NOVA COMET 14DR Lathe
Assembling the Tailstock
1. Insert the wheel handle screw into the
handwheel handle
2. Use a flat head screw driver to screw on the
handwheel handle onto the quill adjusting
wheel and tighten.
Installing the quill lock handle
1. Turn the tailstock quill so the machined
slot is in line with the quill lock handle
hole.
2. Thread the tailstock quill lock handle into
the tailstock body.
3. Make sure the tailstock quill does not
rotate with the handle rotation.
Operating the NOVA COMET 14DR Lathe
Turning the lathe ON / OFF
The LCD digital speed readout will light
up and display “0” when the lathe is
plugged into the power source and “FWD”
LED light of the left side of the will begin
to flash.
LED flashing
Tailstock
Handwheel
Handwheel handle
Handwheel Screw
Tailstock Quill Slot
Tailstock Quill
Lock Handle

Nova COMET 14DR Specifications

General

Brand	Nova
Model	COMET 14DR
Category	Lathe
Language	English