Locking and Unlocking the Spindle
Pull the lock pin away from the headstock and turn the lock pin 180 degrees to switch between the lock and
unlock positions.
Looking from the back side of the lathe, the state that is described on the right-hand side shows the spindle
lock state:
Ensure to lock the spindle using the spindle lock
function before commencing the procedure.
Use the Allen key to loosen/ remove the safety screw
from the faceplate before installing the faceplate.
Thread the faceplate onto the spindle thread all the
way. Ensure the faceplate meets the spindle bearings.
Thread/tighten the safety screw on the face plate to
lock the face plate in place.
Unlock the spindle before turning the machine on.
To Next Page
Loading...
Need help?
General
