Open the bed belt cover by loosening the motor
lock knob to gain access to the motor belt pulley.
Lift the headstock guard to open and gain access
to the spindle pulley + belt.
Remove the drive belt from the motor pulley by
lifting the motor handle plate and making enough
space. There will be approximately ¾” (20mm) of
vertical movement on the motor handle.
1. Place the belt onto the desired spindle pulley
once the belt is removed from the motor pulley.
2. Place the belt on the corresponding step on the
motor pulley.
3. Apply a firm downwards force by a thumb onto
the motor handle plate to tension the belt.
4. Caution: Excessive belt tension may cause the
belt or the pulleys to break.
5. Turn the bed belt cover to close and relock the
cover.
6. Tighten the motor locking knob while applying
correct tension.
Check the belt tension by applying moderate pressure at approximately halfway between the spindle pulley and
the motor pulley. The belt should have a deflection of approximately ½” (13mm) when an appropriate tension is
applied on the belt.
(1) Loosen
motor lock
knob
(2) Take the belt off from the spindle pulley
and place it onto the desired step.
(2) Loosen the cover
locking screw
(3) Lift and turn the cover
(1) Take the belt off from the motor pulley
and place it onto the desired step.
To Next Page
Loading...
Need help?
General
