Novation Launchpad Pro MK3 User Manual

4
Bootloader
Launchpad Pro [MK3] has a bootloader mode that allows the user to configure and save certain
settings. The bootloader is accessed by holding the SETUP button whilst plugging the device in.
The top two rows of pads can be used to set the USB device ID of the Launchpad Pro [MK3]. The
device ID ranges from 1 to 16, the selected ID is represented by a brightly lit pad. The default ID from
factory is 1. If more than one Launchpad Pro [MK3] is used on the same USB, each should have a
different device ID selected.
The single yellow pad on the middle right can be used to toggle Onboarding. When Onboarding is
ON, the Launchpad Pro [MK3] shows up as a Mass Storage Device to provide a more convenient first-
time experience. You can turn this off once you are familiar with the device to disable this Mass
Storage Device.

Novation Launchpad Pro MK3 Specifications

General

Brand	Novation
Model	Launchpad Pro MK3
Category	Recording Equipment
Language	English