2.Heat pump installation
(1).Installation location
◆ Provide sufficient space for installation and maintenance.
◆ Inlet and outlet accessibility, strong wind cannot reach
◆ Unit installed in ventilation place where can bear the weight of the unit, can mount the
unit horizontally, also will not increase the mechanical noise and vibration.
◆ Exhausting air won’t affect the neighbors, no combustible gas leakage.
◆ Should have the snow shed in winter.
◆ Around the unit need drainage channel to drain condensate out.
◆ Installation location should be easy to install, repair and connect.
◆ If installed on the roof, it needs to increase measures against typhoons and lightning.
◆ Do not install the control panel in the bathroom, in order to avoid moisture to affect the unit
Operation.
(2).Installed in the following locations may cause the machine to malfunction.
◆ Places such as cutting oil and other mineral oils.
◆ Places with salted air near the sea.
◆ Places which contains gas such as sulfur, acidic or alkaline and other corrosive gases
in the spa area.
◆ The place is with seriously voltage fluctuations and have strong electromagnetic waves.
◆ Kitchen and other places which are full of oil odor, and oil trace.
(3).Unit infrastructure installation
Units can be installed base of concrete structures, and steel brackets can also be used to install, basic
surface is roughness (basic is designed according to the operational quality and according to the
technical performance parameters table). Under the unit, should install the vibration damping rubber,
and fix with bolts. Adjust the unit installation level, tilt <2 degrees. On the ground should have the
drains for unit's condensate.
Air out
≥300mm
≥2000mm
≥300mm
≥300mm
Air in
Air in
To Next Page
Loading...
Need help?
General
