Numark DDS80 Reference Manual

33
 Calibrate
This function is used to calibrate the pitch sliders. Your DDS
has been pre-calibrated at the factory, but the characteristics
of the sliders may change slightly over time. If the top, center
and bottom positions no longer align with the expected pitch
range you should run this calibration routine.
Select Calibrate, then when prompted:
1. Move both sliders to the fully upward position (to the -
% symbol)
2. Select Next
3. Move both sliders to the center position
4. Select Next
5. Move both sliders to the fully downward position (to the +% symbol)
6. Select Next
NEXT
NEXT
NEXT
Calibration is now complete. Press the Utility button to exit.
Note: If you mix up the calibration procedure by swapping over the minus and plus ends of the
scale, the pitch slider will have no effect! Simply re-run the calibration.
 Updates
The Updates page shows the current software version of
the DDS. Please check http://www.numark.com
regularly
for available software upgrades. If the version of the
software upgrade on the website is higher than the version
of the current software on your DDS, please follow the
upgrade procedure outlined in the next section of this
manual.

Numark DDS80 Specifications

General

Brand	Numark
Model	DDS80
Category	DJ Equipment
Language	English