page 8
INSTALLING HOSE HANGER
If not already done, install the hose hanger by following these
3 steps.
Place one loop of the hanger
over the other (as shown
beside).
Using a screwdriver, secure
the hanger to the wall with the
provided screw. Insert a
plastic anchor if necessary.
Wind hose around it’s hanger
when not in use.
AR0031
AR0029
AR0030
CONNECTING HOSE
LOW VOLTAGE HOSE
To ensure proper operation of
hose, insert hose into wall inlet
(as shown beside). Align tab up
with depression in wall inlet (A).
AO0022
OPERATING HANDLE SWITCH
LOW VOLTAGE HOSE
The switch will turn power unit
ON/OFF.
DUAL VOLTAGE HOSE
Switch on the right position:
Central vacuum mode with power
brush.
Switch on the left position:
Central vacuum mode without
power brush.
Switch in the center:
Power unit is turned OFF.
AD0025
A
A
AD0026
AD0033
AD0032
CONNECTING HOSE (CONT’D)
DUAL VOLTAGE HOSE
In addition to connecting into wall
inlet (A), dual voltage hose must
also be connected to a standard
electrical outlet (B).
If your new hose connection is
not compatible with the telescopic
handle of your unit, please call
1-888-882-7626.
IMPORTANT: Do not return the
hose to the store.
AO0023
B
B
A
A
FOR MODELS: DLXKIT800, STDKIT400, STDKIT800 & WHKIT700
To Next Page
Loading...
Need help?
General
