Nvidia JETSON TX1 User Manual

Jetson TX1 Developer Kit
User Guide
Jetson | Copyright © 2014 NVIDIA Corporation. All rights reserved. Page 4 of 27
Login Credentials
> Username: nvidia
> Password: nvidia
Force Recovery Mode
To update your system, you will need to be in Force USB Recovery Mode so you can transfer system
software to the developer board. When in Force USB Recovery Mode, you are able to update system
software and write the boot loader, boot configuration table (BCT), and partition configuration to the
Tegra device.
See the Developer SDK documentation for OS specific instructions when updating system software on
your developer board.
To place system in Force USB Recovery Mode:
1. Power down the device. If connected, remove the AC adapter from the device. The
device MUST be powered OFF, not in a suspend or sleep state.
2. Connect the Micro-B plug on the USB cable to the Recovery (USB Micro-B) Port on the
device [4] and the other end to an available USB port on the host PC.
3. Connect the power adapter to the device.
4. With the system powered on, press and release the POWER button, if necessary; press
and hold the RECOVERY FORCE button; while depressing the RECOVERY FORCE button,
press and release the RESET button; wait two seconds and release the RECOVERY
FORCE button.

Nvidia JETSON TX1 Specifications

General

Brand	Nvidia
Model	JETSON TX1
Category	Microcontrollers
Language	English