Nvidia JETSON TX1 User Manual

Jetson TX1 Developer Kit
User Guide
Jetson | Copyright © 2014 NVIDIA Corporation. All rights reserved. Page 8 of 27
JetPack
This section is intended to help you get familiar with installing the Developer Pack (JetPack TX1), using
the tools and running sample code.
Before you Begin
> You have a Tegra Developer Kit equipped with the NVIDIA Tegra TX1 processor.
> You have a host machine that is running Linux.
> Your developer system is cabled as follows:
 Serial cable plugged into the serial port J1A2 UART4 on the target connected to your Linux
host directly or through a serial-to-USB converter. (To setup serial console on the Linux host.)
 USB Micro-B cable connecting (J1E1 USB0) to your Linux host for flashing.
 (Not included in the developer kit) To connect USB peripherals such as keyboard, mouse, and
[optional] USB/Ethernet adapter (for network connection), a USB hub should be connected to
the working USB port (J1C2 USB2) on the system.
 An HDMI cable plugged into "J1C1 HDMI1" on the target which is connected to an external
HDMI display.
 An Ethernet cable plugged into the J1D1 on board Ethernet port.
> Download latest JetPack TX1
 The latest version of the Development Pack (JetPack TX1) is available at NVIDIA Developer
.
 All available JetPack TX1 downloads here.
Installing JetPack TX1
The following instructions assume you have downloaded the latest JetPack version, JetPack-
${VERSION}.run, where ${VERSION} refers to the version string for the installer you have.
1. Add exec permissions for the JetPack-${VERSION}.run
chmod +x JetPack-${VERSION}.run

Nvidia JETSON TX1 Specifications

General

Brand	Nvidia
Model	JETSON TX1
Category	Microcontrollers
Language	English