Apple Macintosh > 67
USB connection
If you have not already done so, run the Oki software installer
before following the steps below.
1. Start the Printer Setup Utility.
This is located in the Applications > Utilities folder.
2. Click Add Printer....
3. From the pop-up menu, choose USB.
4. Choose a printer to connect to.
5. Click Add.
6. Click the Printer Setup Utility menu, and choose Quit
Printer Setup Utility.
C
ONFIGURING
PRINTER
HARDWARE
OPTIONS
If you have added additional hardware, for example additional
paper trays, to your printer these must be enabled in the printer
driver.
1. Start the Printer Setup Utility.
This is located in the Applications > Utilities folder.
Ensure that your printer model is selected.
NOTE:
> This utility is called Print Center on Mac OS X 10.2.x.
> If your printer is already listed, your Mac may already
have discovered the printer before you installed the Oki
software. In this case, the printer may be using the
incorrect PPD file or may not have the correct hardware
options configured. You should delete the printer, quit
Printer Setup Utility, and re-launch the utility before
continuing.
NOTE:
Applies to IP and Rendezvous network connections only.
NOTE:
This utility is called Print Center on Mac OS X 10.2.x.
To Next Page
Loading...
Need help?
General
