NETWORK SETTING Menu 1-9
DNS CONFIG.
" When using network scanning and when specifying the SMTP server
as a host name instead of as an IP address, be sure to select
ENABLE, and then specify the IP address of the DNS server.
DHCP
Purpose Sets whether or not the DNS server setting is to be speci-
fied.
If specifying the DNS server setting, the SMTP server can
be specified as a host name when using network scanning.
If ENABLE is selected, type in the IP address of the DNS
server.
If DISABLE is selected, the DNS server cannot be refer-
enced.
Options DISABLE/ENABLE
Default DISABLE
Range (If DNS CONFIG. is set to ENABLE)
0-255 for each xxx triplet
Use the keypad to input each number; use the and
keys to move between triplets.
Notes A single digit number, such as “1”, cannot be input as “001”.
Align the number on the left and input “1” as “1 _ _”. Use
the and keys to move between triplets.
The B
ACK key can also be used for deleting. To cancel DNS
CONFIG. menu, hold down the BACK key for more than
one second, and then press the BACK key again after all
settings have been cleared.
After changing the settings, the machine must be turned
off, then on again.
Purpose If there is a DHCP server on the network, specifies whether
the IP address and other network information is automati-
cally assigned by the DHCP server.
Options DISABLE/ENABLE
Default ENABLE
To Next Page
Loading...
Need help?
General
