Oki MC362 User Manual

- 49 -
4
Scanning
4 Scanning
This chapter explains the initial setup and basic procedure for the Scan to E-mail, Scan to Network PC,
and Scan to Local PC functions.
Your machine supports the following scan functions.
Function Overview
“Scanning to E-mail” Scans documents and sends the scanned images as an attached le of an e-mail to the
specied e-mail address on the network.
“Scanning to Network
PC”
Scans documents and saves the scanned images to the “shared folder” of a computer
on the network.
Scanning to USB
Memory
Scans documents and saves the scanned images directly to a USB memory.
For the procedure for the function, refer to the User’s Guide > “Scanning” > “Scan to
USB Memory”.
“Scanning to Local PC” Scans documents to the computer via network or USB and manipulates the scanned
images as necessary by operating on the operator panel.
Scanning to Remote PC Scans documents to the computer via network or USB and manipulates the scanned
images as necessary by operating on the computer.
For the initial setup for the function, refer to the User’s Guide > “Scanning” >
“Installing Scanner Drivers (TWAIN/WIA/ICA Driver)”.
For the procedure for the function, refer to the User’s Guide > “Scanning” > “Scan to
Remote PC”.
●● Scanning to E-mail
This section explains the initial setup and basic procedure for the Scan to E-mail function.
This function enables you to scan documents and send the scanned images as an attached le of an
e-mail to the specied e-mail address on the network.
Be sure to nish the initial setup before using this function.
Initial Setup for Scan to
E-mail
This section explains how to congure the initial
setup for the Scan to E-mail function. Follow the
2 steps below:
● “Step 1 Conguring the Network Settings of
Your Machine” P.49
● “Step 2 Conguring the E-mail Settings of
Your Machine” P.53
Note
● You need to complete the network setting of the computer
before this procedure.
Memo
● You can skip step 1 if the IP address is already set on your
machine.
Step 1 Conguring the Network
Settings of Your Machine
Connect your machine to a network with an
Ethernet cable, and then congure the machine’s
IP address and other network information from
the operator panel. You can set the IP address
either manually or automatically.
If there is no DHCP server or BOOTP server on
the network, you need to manually congure the
IP address on the computer or machine.
If your network administrator or internet
service provider species a unique IP address
for the computer and your machine, set the IP
addresses manually.
Note
● When setting an IP address manually, ask the network
administrator or your internet service provider which IP
address to use. If the IP address is set incorrectly, the
network may go down or Internet access may be disabled.
● Conform the IP version of the machine to that of your
computer.
● Set [TCP/IP] setting to [Enable] on your machine. (By
factory default, it is set to [Enable].)

Oki MC362 Specifications

General

Brand	Oki
Model	MC362
Category	All in One Printer
Language	English