5 OTHER OBSERVATION METHODS
5-1 Differential Interference Contrast Observation............................................................................... 19-23
1 Attaching the Analyzer 2 Attaching the Polarizer
3 Attaching the DIC Prisms (for Revolving Nosepiece)
4 Attaching the DIC Prisms (for Condenser)
5
Adjusting the Polarizer Position (except the U-UCD8)
6
Observation Method
5-2 Reflected Light Fluorescence Observation................................................................................................... 24
5-3
Infrared Light (IR)/Differential Interference Contrast (DIC) Observation
............... 24-27
1 Introduction 2 Attaching the IR Modules
3 DIC Observation Using IR
5-4 Macro Reflected Light Fluorescence Observation ................................................................. 28-30
1 Introduction 2 Attaching the Modules
3 Filter Characteristics of Fluorescence Mirror Units
4 Fabricating Optional Mirror Unit
6 TROUBLESHOOTING GUIDE
7 SPECIFICATIONS
8 OPTICAL CHARACTERISTICS
9
31-33
34
35
36-42
ASSEMBLY
—
See this section for the replacement of the light bulb. —
PROPER SELECTION OF THE POWER SUPPLY CORD ...................................................................
43, 44
19-30
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with the requirements of directive 98/79/EC concerning in vitro diag-
nostic medical devices. CE marking means the conformity to the directive.
10 LAMP HOUSING INSPECTION SHEET
45
To Next Page
Loading...
Need help?
General
