24
BXFM
ASSEMBLY
10-1 Assembly Diagram
· The diagram below shows the sequence of assembly of the various modules. The numbers indicate the order of assembly.
· The module numbers shown in the following diagram are merely the typical examples. For the modules with which the
module numbers are not given, please consult your Olympus representative or the catalogues.
# When assembling the microscope, make sure that all parts are free of dust and dirt, and avoid scratching any parts
or touching glass surfaces.
}Assembly steps enclosed in will be detailed on the subsequent pages.
}All assembly operations are possible by using the Allen screwdriver ( ) provided with the microscope. However,
the BX-URA2 or BX-RLA2 vertical illuminator should be attached using the Allen wrench ( ) provided with the illuminator
to clamp the internal screws.
Eyepiece
WHN10X (FN 22)
35WHN10X (FN 22)
SWH10X-H (FN 26.5)
35SWH10X (FN 26.5)
Observation tube
U-BI30-2 (FN 22)
U-TR30-2 (FN 22)
U-TBI3 (FN 22)
U-SWTR-3 (FN 26.5)
Intermediate
attachment
U-CA
U-DP
U-APT
Reflected
light
illuminator
BX-URA2
BX-RLA2
Observation tube
clamping screw
Lamp housing
clamping knob
Filter
U-25ND6-2
U-25ND25-2
U-25ND50-2
U-25LBD
U-25IF550
Analyzer
U-AN
U-AN360-3
Polarizer
U-PO3
U-POTP3
Compact reflected
light brightfield
illuminator
U-KMAS
Illuminator holder
BXFM-ILH
Revolving
nosepiece
Illuminator
clamping
knob
Revolving
nosepiece
clamping
screw
Illuminator
holder S
BXFM-ILHS
Objective
adapter
BD-M-AD
Brightfield
objective
Brightfield
objective
Halogen lamp
housing
U-LH100-3
Halogen lamp bulb
12V100WHAL-L
12V50WHAL-L
Focusing unit
BXFM-F
Pillar clamping
knob
Counter spring
BXFM-ILHSPU
Power supply
TH4
Power cord
Hand switch
TH4-HS
Stand
U-ST
To Next Page
Loading...
Need help?
General
