8
4 Detailed observation procedure
1
Turning the LED Illumination ON
If the specimen holding lever
c
is returned with a strong
force or the knob
a
of the specimen holding lever
c
is
released in the middle, the slide glass may break.
· Do not move the specimen by holding the specimen
holder
f
directly by hand, since it will damage the rotary
mechanism of the Y-axis and X-axis knobs.
· When movement of the specimen reaches the limits of
Y-axis and X-axis movement range, respective rotation
tensions of Y-axis and X-axis knobs become heavy. Stop
rotating the knobs in that case.
Rotate the coarse adjustment knob
b
in the direction of the arrow
to fully lower the stage.
Open the specimen holding lever
c
of the specimen holder in the
direction of the arrow, set the specimen by sliding it on the stage from
the front toward the rear.
After setting the specimen, return the specimen holding lever
c
gently.
Rotating the upper Y-axis knob
d
moves the specimen in the Y-axis
direction and rotating lower X-axis knob
e
moves the specimen in
the X-axis direction.
1
2
3
4
2
Placing specimen on the stage
Set the main switch
a
to “ I ” (ON).
Rotating the brightness adjustment knob
b
in the direction of the
arrow increases brightness and rotating it in the opposite direction
decreases brightness. The figures around the knob represent rough
indication of the brightness.
1
2
Cover glass
To allow the objective to bring out its full performance, use the
cover glass with a thickness of 0.17 mm.
Slide glass
It is recommended to use the slide glass with a length of 76 mm,
width of 26 mm and thickness between 0.9 and 1.4 mm.
a
b
Placing specimen
Cover glass
Slide glass
c
e
d
f
b
a
To Next Page
Loading...
Need help?
General
