Before carrying the motorized stage, detach the stage plate and the plate (high-precision plate or black-
and-white plate).
If you carry the motorized stage, hold the surface (painted in gray) of the motorized stage .
As the connector is attached to the bottom of the motorized stage, be sure to place the motorized stage
only on the stage mount of the microscope frame. If it is placed on the desk, etc., the connector may be
damaged.
When you set up this system, detach the transport locks of the zoom head, stage and microscope frame.
As these transport locks will be used for transporting this product next time, keep them in a safe place.
If you need to package this product, such as to ship to the distant location, you need to use the
dedicated package box. In this case, be sure to contact Olympus for assistance.
If you transport and install this system overseas by yourself without prior notice to Olympus, the services
in the destination country will not be provided.
If you transport and install this product overseas, note the following:
・Use the power cord that complies with the regulations and rules of the destination countries.
・Use the controller that complies with the regulations and rules of the destination countries. Depending
on the case, you may need to purchase only the controller for local use.
・Some countries and regions may not have established the Olympus service system. In this case, the
product for repair or other purposes must be sent to Olympus in Japan.
・Note, even in countries and regions where the Olympus service system is available, the same after-
services as those in Japan may not be provided.
To Next Page
Loading...
Need help?
General
