46
EN
Appendix
Battery and AC adapter
(included)
This camera uses one Olympus lithium ion
battery (LI-70B). No other type of batteries can
be used.
Caution:
There is a risk of explosion if the battery is
replaced with the incorrect battery type.
Dispose of the used battery following the
instructions. (p. 52)
Power consumption by the camera varies
depending on which functions are used.
During the conditions described below, power
is consumed continuously and the battery
becomes exhausted quickly.
The zoom is used repeatedly.
The shutter button is pressed halfway
repeatedly in shooting mode, activating the
auto focus.
A picture is displayed on the monitor for an
extended period of time.
The camera is connected to a computer or
printer.
Using an exhausted battery may cause the
camera to turn off without displaying the
battery level warning.
The rechargeable battery is not fully charged
at the time of purchase. Before use, charge the
battery fully with the supplied F-2AC USB-AC
adapter (hereafter referred to as AC adapter)
or an optional AC adapter (F-1AC/D-7AC).
When the included AC adapter is used,
charging usually takes approximately 3 hours
(varies on usage).
The included AC adapter has been designed
to be used only for charging. Make sure that
operations such as shooting, viewing images
and so on are not being used while the AC
adapter is connected to the camera.
The included AC adapter is designed to be
used only with this camera. Other cameras
cannot be charged with this AC adapter.
Do not use with other devices.
For plug-in type AC adapter:
The included AC adapter is intended to be
correctly orientated in a vertical or fl oor mount
position.
•
•
•
•
•
•
•
•
•
•
•
•
•
Camera care
Exterior
Wipe gently with a soft cloth. If the camera is
very dirty, soak the cloth in mild soapy water
and wring well. Wipe the camera with the
damp cloth and then dry it with a dry cloth. If
you have used the camera at the beach, use a
cloth soaked in clean water and wrung well.
Monitor
Wipe gently with a soft cloth.
Lens
Blow dust off the lens with a commercial
blower, then wipe gently with a lens cleaner.
Battery/AC adapter
Wipe gently with a soft, dry cloth.
Do not use strong solvents such as benzene
or alcohol, or chemically treated cloth.
Mold may form on the lens surface if the
lens is left dirty.
Storage
When storing the camera for extended
periods, remove the battery, AC adapter and
card, and keep in a cool, dry place that is well
ventilated.
Periodically insert the battery and test the
camera functions.
Avoid leaving the camera in places where
chemical products are handled since this
may result in corrosion.
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
Weight and Dimensions
