Olympus OFP-2 User Manual

Chapter 2 Nomenclature and Functions
FLUSHING PUMP OFP-2
15
1.4 Accessories
Chapter 2 Nomenclature and Functions
2.1 Front panel
1. Power switch and indicator
This switch is pressed to turn the power ON or OFF. The power indictor will illuminate green
when power is ON.
2. Standby switch and indicator
The standby switch changes the unit from “standby mode” to “run mode”. The standby
indicator illuminates green when the unit is in “run mode” and amber when in “standby mode”.
The unit goes into "standby mode" when the pump head lever is open.
3. Flow rate controls
Increases “” or decreases “’’ the flow of water to the endoscope or the EndoTherapy
device by pressing the  and  switches as required. The flow rate is stored in memory
until the unit is switched OFF.
Product Description
MAJ-1603 Water container (pack of 3)
MAJ-855 Auxiliary water tube
MAJ-920 Remote control cable
Figure 2.1
OFP-2
2. Standby switch
and indicator
3. Flow rate controls
5. Footswitch
connection port
6. Pump head
4. Flow rate indicators
1. Power switch
and indicator
7. Pump head
release lever
8. Water container tray
9. Pump head lever

Olympus OFP-2 Specifications

General

Brand	Olympus
Model	OFP-2
Category	Water Pump
Language	English