Chapter 11 Technical description
FLUSHING PUMP OFP-2
58
Olympus specified parts.
WARNING
• Use of this equipment adjacent to or stacked with non-Olympus
equipment should be avoided because it could result in improper
operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
• Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than
30 cm (12 inches) to any part of the OFP- 2 including cables specified
by the manufacturer. Otherwise, degradation of the performance of this
equipment could result.
NOTE
The EMISSIONS characteristics of this equipment make it suitable for
use in industrial areas and hospitals (CISPR 11 class A). If it is used in a
residential environment (for which CISPR 11 class B is normally
required) this equipment might not offer adequate protection to radio-
frequency communication services. The user might need to take
mitigation measures, such as relocating or re-orientating the equipment.
11.4 Electromagnetic emissions
The OPF-2 intended for use in the electromagnetic environment specified below. The customer or
the user of the OPF-2 should assure that it is used in such environment.
Emission tests compliance Level
RF emissions CISPR 11 Group 1 Class A
Harmonic emissions IEC 61000-3-2:2018 Class A
Voltage fluctuations/flicker emissions IEC
60000-3-3:2013 and AMDI:2017
Complies
To Next Page
Loading...
Need help?
General
