EN 24
EN
Water Leakage Test
The final test after loading the camera is explained below. Always perform
this test. It can be performed easily in a water tank or a bathtub. Confirm
the operation of the different buttons. The required time is about
5 minutes.
• At first, immerse the Case for only 3 seconds and check that no water
enters the Case.
• Next, immerse the Case for 30 seconds and check that no water drop
etc. has entered the Case.
• Then, immerse the Case for 3 minutes, operate all buttons and levers,
and check the following:
- check that no water has entered the Case.
- check that the Case is not clouded.
- check that no water drop has entered the Case.
• If the inside of the Case becomes cloudy or there is a water drop, do the
maintenance of the O-ring and perform the water leakage test again.
PT-057_EN.book Page 24 Friday, November 21, 2014 10:13 AM
To Next Page
Loading...
Need help?
General
